Tractor Talk Discussion Board |
Dog Gone Scammers!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Short Bolt on December 17, 2005 at 16:23:07 from (69.21.20.47):
Don't know what all problems ,ya had with scammers. But I'm really ticked. I put my Miller Maxtron welder in the classified adds.At $1000.00 or trade for a old rough tractor. Which is well under priced, according to most .It was only used 1 year and has been in storage in the dry in a box since 97. Well I had several replys (2) which really intrested me. One guy was going to trade me a 1947 M that ran good had poor rubber, needed paint,and had as he said the usual M problems of 6 volt system. I told him I would accept his Offer. Now he won't anwser a E-mail or phone call. The second said if I could find a tractor near me I liked he would pay for the tractor, Well i Did $500.00 . I told him if he bought it and gave me $250.00 cash I would give him the welder. Now he says that he can't come up with that much money but wants the welder. So now I turned off all the other traders, And here I set.Some People.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|