Posted by Michael Everitt on August 14, 2014 at 09:54:26 from (98.24.8.117):
I am nearly done refurbishing (Not restoring) my 1940 9N . I have to scrap the two doglegs and the grill since they are rusted out and have been tack welded many times. I have new legs and a new grill. I cannot find a 9N to look closely at... so I am not sure how the doglegs and grill are fastened to the frame. It seems that there are only two bolts (3/8")... at the bottom of each leg that bolt to the bottom of the grill, and two bolts on each leg that fasten the legs to the hood on the sides. Then the grill has two spring detents that fit into the hood. Does the hood simply rest on the top of the radiator with the "cushion" around the fill neck supporting it? It would seem that the bottom of the legs should bolt to the frame or radiator somewhere for stability, but I do not see where. Possibly there's a bracket missing? Any help (including photos) will be much appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.