Posted by J. Schwiebert on February 01, 2014 at 12:17:44 from (209.173.169.187):
In Reply to: Masey 33 Help posted by squaredt on February 01, 2014 at 11:53:44:
If I understand you correctly the valves stick out of the head too far. If that is true the machine shop did not check his stem height. That also means the rockers arms are "running up hill" so to speak. This is going to probably restrict the flow of oil to the valve stems as well. Did they install seats in the head or just grind the seats? Now those little caps you are talking about are hardened. So forget the file. How much do you use the tractor? There is also a specified clearance between those little caps and the end of the valve stems. A flat washer under each rocker arm support may correct more problems than just being able to adjust the valves. Questions? Post an e-mail or phone number and we can discuss it in more detail. My 2 cents worth and yes I have done machine shop work. J.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.