Farmall & IHC Tractors Discussion Board |
Re: Farmall M clutch adjustment remaining?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on July 05, 2007 at 23:33:43 from (64.12.117.8):
In Reply to: Re: Farmall M clutch adjustment remaining? posted by chadd on July 05, 2007 at 19:27:52:
Chadd, like Scotty said, if you have adjusted the free travel and about to run out of threads in the direction you turned it, your clutch is getting thin. As long as your free travel is right that is all you can do. Just take note of the direction you turned it to get the free travel adjusted right. If that clutch slipped as you say and was adjusted then, I would almost bet it is getting thin. As long as there is free travel the bearing is not riding the fingers. I do see what you are saying, and it does seem to make sense, but for some reason I don't think it works that way. so you will have to take notice of the direction you turned it and that will tell you how much disc is left. Once you have ran out of threads it is about done. The three sitting here are almost as long as they can get. None of them have had a new clutch in many years, so I am sure they are thin.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|