Farmall & IHC Tractors Discussion Board |
Re: HELP !! 300 UTILITY
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TDK on February 17, 2007 at 21:12:37 from (64.12.116.71):
In Reply to: HELP !! 300 UTILITY posted by tom nj on February 17, 2007 at 15:52:02:
Tom, you described the tractor shaft perfectly. This is all fresh on my mind because we just rebuilt a trans/diff. in a 330 this week. Your tractor was meant for the trans. driven pto. The shaft on pto has a pilot that fits into the pilot hole you mention & it has a hollow tube with splines that will cog up with the splines on the tractor shaft when engaged. You need to find a trans. driven pto, as changing tractor over to IPTO will be a lot of trouble and probably expensive. Hope you get it worked out.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|