Farmall & IHC Tractors Discussion Board |
Re: Road Trip
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scot_c on June 07, 2005 at 19:06:44 from (69.40.133.21):
In Reply to: Road Trip posted by Allen in TN on June 06, 2005 at 10:06:23:
About an hour (45-50 miles) from effigham in Olney IL (the place with the white squirrels according to some of the drivers i've talked to from there) pacific cycle has a big warehouse and factory outlet store. I guess most of what they sell has blemishes but are cheaper than in a store. At least that's what they told me when I picked up a load of bikes there back in february Take route 33 east/south to newton then go south on state route 130, cross u.s. 50 (that little diner there has pretty good food) and around the corner turn left on tower road it's on the left. If you like flat land just drive around some state routes it's a nice area. From tower hill (nw of effingham) I was listening to 1190 am out of fort wayne in the truck. I don't know where you are from in TN but taking 33 to 130 to route 1 to I-64E to I-164S to get to the pennyrile(?) parkway is a nice way to get to nashville from there. You also have u.s. 40 (national road) running through town. In albion there's a place where they make filters. exciting. There's not a whole lot there. I'd suggest the gateway arch but it's a ways off yet and traffic on I-55/64/70 is real bad crossing the river.
Follow Ups:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|