Farmall & IHC Tractors Discussion Board |
Re: Rebuilt Carb on 300 U Leaking Gas
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron Smith on April 03, 2005 at 11:02:22 from (205.188.117.73):
In Reply to: Re: Rebuilt Carb on 300 U Leaking Gas posted by Ron Smith on April 01, 2005 at 19:51:24:
Dropped the bowl down this morning and found that one side of the float was full of gas. Pulled the pin and Removed the entire float. The float is split open on the bottom where it is seamed together. Took awhile for all of the gas to drain out. I'll see if I can find a new float tomorrow and will go from there. When I looked in the bowl before dropping it down entirly, I could see that the float was fairly well submerged in gas. I guess it did raise up enough to shut off the gas flow since one side was still working. I'll put in a new one and go from there. Maybe that will take care of it. I am surprised it would run as well as it did with it like that. It just wouldn't throttle up properly.
Follow Ups:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|