Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Plumbing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PAULIH300 on January 30, 2005 at 19:25:09 from (152.163.101.13):
In Reply to: Re: Hydraulic Plumbing posted by CNKS on January 30, 2005 at 19:14:40:
All the loader hoses connect to a junction box bolted to the side of the chassis.The only QDs are on the dump piston hoses (which double as log splitter powering hoses when swapped to the rear). I think I will remove that crossover hose and plug the HT port and see what happens. (oh and shift to S too). This fitting at the reservoir has to be factory,I cant imagine them drilling one out.Its on the left and is low on the reservoir.Maybe they thought that doing this would provide the lift cylinders with 2 sources of fluid (?) but that makes no sense.When the lever is powering upward,the other side of the valve (when on D)is bleeding off fluid.When the lever is "lowering" the 2nd line is powered and the lift cylinders are bleeding off.Confusing....
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|