Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Plumbing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on January 30, 2005 at 19:14:40 from (204.249.178.138):
In Reply to: Re: Hydraulic Plumbing posted by PAULIH300 on January 30, 2005 at 18:20:54:
I'm getting more confused -- didn't think that was possible. Lets start over--you have 2 remotes, the one that tilts the bucket has a 2-way cylinder, 2 hoses. I assume the remotes have the factory "blocks or sockets" that you plug hoses into. Just swap the hoses on the tilt remote, and back is up forward is down, if that's the way you want it. On the port that lifts the bucket, bucket has one way cylinders: "the lift hose is on the rear port, the hose that crosses over is connected to the front". You mean that the lift hose is plugged in to a quick disconnect, or to one port in the block? What is the crossing hose connected to -- you say "front" that tells me it is connected to the valve housing, not the other port in the block (or the other quick disconnect), in which case the valve should bleed off the pressure when in the single position, provided it returns to the right place in the reservoir, also provided it is connected to the right place in the valve body. If it is plugged into the other port of the block, or you have quick disconnects that are for some reason separated (but work off the same valve), that is your problem -- unplug it. If the latter is the case, that is two quick disconnects connected to the same valve, with the lift hose in one and the return hose in the other, that return hose has to come out, and the valve set to single acting -- I think.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|