Posted by Richard from SE AZ on March 31, 2011 at 21:48:35 from (206.169.89.203):
In Reply to: coal miners posted by onedeere37 on March 31, 2011 at 08:57:04:
I am a retired underground miner having worked in hard rock mines all over the West ,Alaska and a few foreigh countries.As has been mentioned before, the rock bolts ,as they are called, are used to hold up ground that may loosen if not kept tight against itself. There are different types. the old style are expansion bolts that have a threaded wedge in the center of the shell that is pulled into two ridged metal wings that tighten against the ground. More common now are split set bolts that work like a roll pin and tighten when they are driven into a hole of smaller diameter. There are also support bolts that are concreted in and some that use epoxy cartridges that mix when the bolt is rotated into the hole. All have a plate on the end that bears against the ground. It is illegle to EVER remove a bolt that has been installed. That is an MSHA infraction of the highest magnitude.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.