Posted by Fixerupper on March 20, 2011 at 16:35:51 from (207.199.205.40):
First time in at least 20 years a running engine has been in the critter. 817 cu in of Waukesha gas engine roared to life yesterday, filling the shop with smoke from the 'pickling oil' I had shot in the spark plugs four years ago after I put new pistons and sleeves in it.
All was well until I saw diesel fuel from a torque converter return line shooting all over the engine bay. The 3/8 in. steel overflow line that runs from the top of the converter cooling radiator down to the reservoir had ruptured from water freezing in it sometime during it's retirement and it happened to be in a place right above the engine. So we shut her down before we got the chance to see if the torque converter will make motion. Gave it a hot soapy water bath, walked out of the shop and called it a day.
Replaced the steel line with new tubing today but I don't want to run it till we top off the torque converter reservoir. Can't wait till tomorrow. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.