buickanddeere said: (quoted from post at 14:50:09 03/11/11) Heavy draft load such as ploughing is done with
semi-mount equipment. So no place for it and no
advantage.
Anything with a pto and a drawbar is not feasible.
Three point hitch drawbars are wobbling widow
makers allowing towed loads such as wagons sway.
These draft transfer hitches have also assisted
equipment operators to kill themselves with flip
overs.
Extra cost.
Time and labour to remove and re-install.
Any one of those reasons are enough for manufacturers to scrap the weight transfer
hitch.M4WD works much better.
buickanddeeere:
I was aware of some of the obvious "do not" actions for such a contraption. Aware of semi mount plows and pto--since pto is 90% rolling load and needs perfect geometry. Some other things you mentioned, I was wondering about, and a couple I forgot to consider (hassle to R&R and cost). Appreciate the comments.
karl f
This post was edited by karl f at 06:42:46 03/12/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.