Posted by PJH on March 10, 2011 at 06:56:14 from (50.40.175.34):
In Reply to: Is this safe? posted by GeneMO on March 09, 2011 at 15:44:37:
I've worked on highway lighting fixtures that were just tiptoe too high for a 40' knuckle boom truck. If I stretched, I could barely reach the fixture. The truck was controlled from the ground, boom was jerky - had to keep your knees bent to keep from feeling like you were going to get flipped out of the bucket. It was equipped with pilot operated check valves to keep the boom up if something failed, so I worried more about getting down in a failure, but my greatest fear was that some fool would run into the truck while it was fully extended. It would be like riding a flyswatter.
My point - the guy in the bucket has to trust the operator, and if the operator hasn't proved himself - the bucket guy will balk at getting in the bucket. I have refused to work with some operators, sometimes because I did not know them, sometimes because I'd seen them in action.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.