If you have not seen it nurse yet, it's not getting anything. Several calves a year, (one just last night) we have to "teach" the calf to suck. It's like they just don't quite know what to do. If I have not seen the calf nurse within 4 hours of birth, this is what we do. I get the calf next to the cow in a nursing position, stick my ring finger in the calf's mouth and get it started sucking on that, then using my middle and pointer finger I reach around the cows teat and slid that into the calf's mouth. Then as the calf begins to get the milk from the teat I slowly remove my finger while making sure the teat stays in the calf's mouth. It may take several times of doing this, and is much easier if you have someone near the cow to keep her from moving around. May even have to tie her up if she is to lively. I always give the cow a few scoops of grain, and that usually keeps their attention while I'm working with the calf. Also, make sure the cow's teats aren't scabbed over. Some cows will get a hard scab on the teat, and until you get that removed, the calf won't get any milk. (Yours must not be if you have seen milk dripping though. After several days old, they should be bouncing like little rubber balls around the pen. If you have any other questions I could maybe help with, just let me know. I hope all goes well with the little bugger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
