Posted by PJH on January 20, 2011 at 18:01:23 from (71.171.215.42):
In Reply to: meat grinder posted by larry@stinescorner on January 20, 2011 at 15:14:50:
Larry - is that a Hobart grinder?
I've got a big old Hobart grinder that resembles yours, or it might be like Mr. Martin has. I keep it out in our old smokehouse, and one year I turned it on without looking it over good. The brush area of the motor had a big mud dauber nest in it, and it wiped out the whole brush assembly. I checked with Hobart for parts, and when I gave the parts guy the serial number, he laughed so hard he could hardly talk. He said it was made in the 40's, and parts no longer available.
My old neighbor worked as a machinist and had everything I needed to repair it. Now I keep duct tape over the vent holes until I use it again.
GOOD grinder, but needs wheels on it - too heavy for one man to handle safely.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.