Posted by paul on January 20, 2011 at 13:07:38 from (66.44.132.120):
In Reply to: mills posted by Jamo58 on January 20, 2011 at 09:50:39:
You got good replies so far.
There is also a - can't think of the term - a mill that crushes the corn, some folk feel it's better for caves, no sharp edges of cracked corn.
Dern it, getting old, can't think of what it's called.
Hammer mill is probably most common for doing a volume of feed, they have different sized screens (tough metal, 3/8 to 1/5 inch holes it pounds the grains through). These days most are pto powered mixer-mills, with a bin on them to hold & blend the different feeds together. Older ones were only a hammer mill, feed came out od a pipe & you had to collect it in a wagon or bags or what. The old ones were often belt driven, kinda set them up for winter & use them, or run off a power unit.
Bur mills you set the distance between the grinding rods or plates to adjust how course or fine you want the grind. Much slower.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.