Posted by RodInNS on January 14, 2011 at 19:49:47 from (216.118.158.123):
In Reply to: Ford Tractors ??? posted by dave2 on January 14, 2011 at 14:46:40:
The 3000 is about 40 PTO hp and 48 engine hp... IIRC, the 3055 is an early derivative of the 3000 that used the 4000's double reduction (planetary) rear axle. It retained the 3000's engine and power spec. The 4100 is a bit later model ('76-'81) that used the 4600 rear, the 3600 front axle and an oddball 183 cid engine. Not that it's a bad engine... it was just a one off for that model and probably not so well supported today. I wouldn't worry about the 3055. I wouldn't really worry about the 4100 either. I'd just plan on installing a 201 engine should the need arise... All Ford's after 1965 were 'world' tractors assembled from components manufactured at various plants with final assembly done at Basildon UK for the UK and world market, at Antwerp, Belgium for the European market and at Highland Park and later Romeo Michigan for the North American market... ALL engines were assembled at Basildon. Most transmissions were done at Basildon. S-O-S transmissions at Highland Park. Lift covers I believe were done at Antwerp... and so on. There's few worries with those tractors if they're in good working order.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
