I understand the damper doors, etc. That part works, tho in 2010 it very, very likely is not to code in a dwelling. Not much at all is to code any more because there are so many reams of code..... Legal issues aside, I understand & it can work fine.
Your problem is an 8 inch furnace output implies it needs an 8 inch chimney.
You can't really reduce that down to 6 inch and expect it to work.
The extra 2 inches of smoke will try real hard to get around the dampner, etc. of your stove, and there you might actually be doing something deadly. Throttling backa chimney is not a good idea.
I don't think it is wise to throttle down the chimney to a 6 inch, when the furnace has an 8 inch output. I think that will give you major problems.
I'm only a simple dirt farmer, don't know much on heating & heating code, so just my opinion. :) Hope you figure out something to make it work properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.