Posted by 550Doug on August 01, 2010 at 15:11:41 from (64.7.137.46):
It turns out the reason my Cockshutt 540 was backfiring and wouldn't start was because the distributor shaft (Delco 12V #111717)was almost siezed and was pulling the dist out of time. I've pulled apart the distributor and inside the casing there is a bushing in which the shaft turns (supposed to). I suspect that with sitting for a couple of months some moisture has created problems. Morever, according to the parts manual there should be an oiler installed on it, but is missing from mine. There is a plug that I can remove and I could get some oil inside however, the oil would not get to the rotating shaft because there is no hole in the bushing. So I could struggle and try to remove the old bushing and install a new one; but I've cleaned up the old one and it now is very shiny inside. So I'm thinking that I should just drill a hole through the old bushing, re-install the shaft, and rig up a piece of piping to get oil into the shaft. Any suggestions? Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.