Posted by Bob on June 28, 2010 at 22:41:09 from (69.178.228.68):
In Reply to: i need a gizmo.... posted by ericlb on June 28, 2010 at 14:38:13:
In 1948, IMHO, there would have been a ROD all the way from the balljoint at the carb to the choke knob in the dashboard.
If your setup has a CABLE involved, I'll bet someone has been "creative", and it's NOT OEM.
It would be NO big deal to make an adapter to connect a cable to the choke arm.
I recently did a similar project to connect a throttle cable to the carb on an SBC I installed in place of a Dorf flatty in a 1953 F6.
If you can't otherwise solve the problem, contact me, I'd enjoy whipping up an adapter for your project.
bigcoulee@hotmail.com
(AFTER I typed all this up, I got to thinking perhaps you simply have the wrong carb and it has a BALL on the end of the choke lever instead of a little brass "barrel" that has a hole for the choke wire. If so, I can help you out!)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.