Posted by Rod in Forfar on June 21, 2010 at 16:39:16 from (64.118.26.65):
I'm looking for answers to the old question: at what speed do I run my finishing mower?
It's a recently-acquired '81 Bolens G174. That's a 41" wide, 17 hp, 4WD, diesel tractor with tall wheels and turf tires. It came with a 3 pt. hitch-mounted Woods 48" finish mower, model RM48YM-2. The thing cuts like a bandit, but the manual's specifications call for PTO settings of 840 rpm or 1000, giving blade rpm of 3126 or 3722. At top speed that's 16,380' per minute, or about 180 miles per hour tip speed.
Then we come to the Bolens's 3-speed PTO. At 2700 rpm, it offers choices of 472, 752, and 1177.
I have put a tank and a half of diesel through it so far, mostly cutting hay out from between young trees -- pretty heavy work. I don't run it at anywhere near full speed, more like 2/3, and it cuts very well at PTO selection 2. When the blades get dull the tractor doesn't lose speed, just beats the daylights out of what it can no longer cut.
My question is for someone who owns a similar tractor with a 2 cylinder Mitsubishi engine: how fast is full speed? (2700?) what's idle? (1000?) what's a reasonable speed for cutting in 1 High? For very intricate or heavy cutting I drop down to 3 Low, but it's a huge drop in ground speed and the mower plugs more readily.
The tractor has impressed me with its strength and versatility. I'd like to know if reasonable revolution choices can hurt it, or can experience with other old engines carry over to the 2 cylinder Japanese wonder.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.