Posted by Don-Wi on May 28, 2010 at 21:03:52 from (75.219.210.36):
We got 1 1/2" of rain on Wed. afternoon/evening, and the feilds are still too wet to get out and plant corn. So instead we decided to start up hay, and with anyluck try to get it all off in the next 3 days. I started cutting today after replacing the suction and bypass lines going to the PTO pump on our hydra-swing haybine (14' wide Hesston 1014+2). Cut 5 acres right next to the barn just to make sure it was working ok, and then after supper went to a feild we're buying the hay from and started cutting.
Lets just say it's thick. Really thick. Was seeded last year with clover and alfalfa, and the conditions were just right the last few weeks and it took off like a shot. Gotta go in 3rd low on our Massey 285, and then 1/2 the time need to have the multi-power pulled back. Espescially when going back up the ravine. Actually saw some smoke roll from the stack on the 285, which is a fairly rare occurance for it anymore, and not to mention while cutting hay. I think the feild is somewhere around 12-15 acres, and I'm still not done. I cut for about 3 hours until I plugged twice from the excess dew and residual moisture in the hay from the rain. Unplugged it the last time but still have a little in the crimper rolls I need to dig out.
Did I mention that the chopper and one of our wagons isn't ready yet?? We were gonna work on them during the week and then do the hay next weekend but the plans have changed. Need to reline the chopper's spout with plastic, fix busted wood under the wagon, and then put the repaired tandem underneath it yet. I still have about 30 acres or so left to cut too. Small for some, but not for us. I belive we can do it, it's just gonna take some skill and well planned days. Hopefully nothing breaks....
Just trying to wind down a little before crawling in bed. Lots to do the next couple days.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.