With the ignition "ON", points closed, WHAT voltage are you seeing on the primary terminal on the coil that is connected to the ignition switch... if full "12 Volt" battery voltage, you need a coil with a primary resistance in the 3 - 4 Ohm range.
If the voltage measures in the 6 - 8 Volt range, that indicates there's a ballast resistor in the circuit and you can use a coil marked "Use with external resistance".
These voltage readings ASSUME the points are closed and making contact AND the primary of the coil is not "open". In other words, the primary circuit must be intact and flowing current or the voltage measurements will be meaningless.
As to the secondary resistance, it will likely be in the 6000 Ohms to 12,000 Ohms range, measured from either of the primary terminals.
(There will be a tiny variation in the secondary Ohms reading depending upon from which primary terminal the measurement is made 'cause one way the primary resistance will be in series (added to) the secondary resistance.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.