The reason I didn't really want to use steel is because 1) the cost and 2) every time I have to cut it for a tee, elbow, etc, it would be back to the hardware store for threading..
I'd really like to use something like truck air line, but can't seem to find anything than 1/2 OD.. which is not enough volume, in my opinion.
What about using a large rubber hose (like a 3/4 air hose) and just putting steel drops where I want them? The rubber would be easier to work with IMO.
And sorry, I didn't mean to start a battle.. what actually started it is I think it was a Summit Racing Catalog showed a "plumbed air in a box" for a standard garage, decided eh, not enough volume.. to which someone suggested pvc.. Which I too am a touch leery about.. And I got to do something, cause I am tired of tripping over air hoses.. and it takes about 50 feet to go from compressor to work bench.. thought it'd be nice to have a drop by both benches with a coil hose, and a port going outside, and one in about the center of the shop for the upcoming paint project.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.