Tractor Talk Discussion Board |
screw between butterfly and intake manifold?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by slughammer on June 01, 2001 at 08:39:59 from (12.13.248.14):
I have a 1977 allis chalmers 720 "garden tractor" it has a 20hp gas Onan engine and I am currently running a 60" belly mower. The engine is 2 cylinder horizontally opposed. The carburator has the fuel needle going up thru the fuel bowl. There is also a needle after the butterfly, just before the intake manifold. I had the carburator off and this needle simply goes thru the wall of the body, looks like a way to introduce a manifold leak to the system? Why would I want to do that? Should I try closing the mystery screw and then adjust the fuel needle? Or is there some amount that I should have this open? Any advise on setting up this carburator would be greatly appreciated. Thanks-Slughammer
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|