Tractor Talk Discussion Board |
Loader Hydraulics wimpy, why?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rick from Paso on May 30, 2001 at 23:31:56 from (63.174.83.45):
I adapted a Cat2 bolt on 3 point and put a box scraper on my Case 310B, this works great. When I run the cylinder to its limit in either direction it will kill the engine running at idle. I assume this is because I have the relief valve pressure set too high. On the front end, the loader cylinders have a hard time lifting a full bucket of sand, even with the engine reved to governed speed, especially when the fluid gets hot. I hear the relief valve going pretty quick on the control valves for the loader. I was thinking that perhaps I need to increase the relief pressure on the loader valves. Any suggestions? Thanks for your help. Regards, Rick from Paso.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|