This has probably already been discussed to death, but 10 gauges are still around new. Local store here was selling H&R single-shot 10 gauges a few years back for $75 each.
The "4 gauge punt gun" is not 4 gauge.
"2 gauge punt guns" were actually 4 gauge. "4 gauge punt guns" were actually 5 or 6 gauge.
There used to be some hand-held 4 and 8 gauge shot-guns, but they got banned for water-fowl use in 1918. Only 10 gauge or smaller was allowed after that.
Parker used to make an 11 gauge shotgun. Martini used to make a 14 gauge shotgun. Winchester used to make a 15 gauge shotgun. Stevens and H&R used to make a 24 gauge shotgun. Winchester used to make a 32 gauge shotgun, and the 410 later took its place. A 410 shotgun shell can be used in a 45-70 rifle if wanted.
That's just the US centerfire shotgun shells. There was a bunch of rim-fires also, like the 310 Remington.
Then there's the British stuff. The Brits had a "0 gauge" shotgun shell - but it was actually close to the size of a US 10 gauge.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.