Tractor Talk Discussion Board |
camshaft
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TE20 GUY on May 14, 2001 at 21:55:20 from (199.76.206.215):
I'm at my wits end !!! I have just recently started to restore my TE20 ,just rebuilt the motor ,runs like a top ,but I can not get any oil to the top of my rocker arms,I have torn the darn thing apart again ,checked all my oil galleys (all clear),checked all bearings (correctly installed), has great oil pressure maybe even a little high ,I installed a new camshaft (threw the old one away)the only thing I can think is someone sold me the wrong cam ,it doesn't have an oil journal hole in the very back of it ,not sure if the old one had it or not ,but I can't firgure out how the oil would get up there without a hole in the back of the cam?any help would be great !!!!!TE20 Guy
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|