Posted by sotxbill on February 15, 2010 at 16:58:10 from (70.234.232.152):
In Reply to: Maybe OT Type of oil posted by Cockshutt Mike on February 14, 2010 at 21:47:12:
cummins had documented the seal problem.. in the late 70s silicon seals where becoming the fad and they found out the hd oils actually removed the silicon from the seals and the seals would prematurely harden and start leaking early. End result was that the seals where changes slightly and the problem went away. The hd detergents actually leached the silicon out of the seals. hd diesel oils are designed for a design use of 10,000 miles between oil changes with an engine life of a million miles... the oil is fortified so that if you miss a change, it will survive for 20,000 miles with out the thickening that light duties oils do. Although it carry more dirt with the detergents, the additive package should still keep acids under control. However remember that the more soot and dirt it carries, the higher the wear rate becomes. If your willing to do periodic oil analysis, you can safely extend oil changes, particularly on newer engines and light run engines, wear the oil analysis will also tell you the change oil sooner on older engines, or engines run very hard. Cummins also developed a special line of oil filters under its fleetguard brand name. some of the extended run filters have 3 types of filters, or even 4 filter sections... a conventional filter, a water/moisture asorbing filter, an centrifical section, and a small particle section. These filters extend engine life and oil filter changes. These filters are optional filters to regualar filters for some of the cummins engines.. like my fl3000 filter is a special part filter over the the standard filter. Its now superceeded by a newer filter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
