RVS said: (quoted from post at 08:58:55 12/15/09) I have a30x40 workshop with an oil forced air furnace and aheat exchanger for my outdoor furnace to heat my shop now. My question is,How can I put radiant heat in my concrete floor that i have now? Can I put down the tubing and cover with 2-3" of new concrete? Will the new concrete stay in place?Will it Crack?Do I have to prep the old floor to make the concrete bond,Do I need to reinforce the new concrete?I pretty weel know how to put in a new floor with this system,but not sure how to add it my floor.
Thanks
Ron
Pretty common here for houses. Not sure how it'd hold up in a shop traffic, but should be OK. Everything is laid out/tested then about 2"x2" reinforceing mesh/wire on top and cement about the consistency of a milkshake is flooded in. it levels itself out and when dry, can be finished w/ tile, painted, or whatever.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.