Posted by thompsonrc on October 19, 2009 at 04:15:36 from (208.103.136.44):
greygoat said: (quoted from post at 07:47:30 01/08/09) Try www.smokstak.com, its and antique gas engine
and steam engine site. There are several different
catagories, including one on magnetos, where you
can ask questions, and lots of knowledgeable
people answer.
I have a WICO, master parts book, about 6 inch"s
thick, gives directions on how to do it, and specs
for different engines. I"ve never done it, but
think it"s just a matter of adjusting the stops
that trip the impulse. A test stand may be
required to do it right. My e-mail is open, send
an e-mail and i"ll copy those pages and forward
to you.
Hi. I have an Allis B with this WICO XH1113 mag and it does not run smooth. Can you scan in the pages of your book that refer to this modifications to make it work with an Allis B? I do not think my mag was set up correctly in the first place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.