Posted by ScottyHOMEy on October 09, 2009 at 08:05:29 from (71.241.217.47):
In Reply to: Farmall A oil pan posted by Gary Spear on October 09, 2009 at 07:48:15:
The motor holds five quarts. Nowadays, yes, those are level checks. A lot of folks treat them like the full and add marks on a dipstick. As long as you get oil out the lower one when you just crack it open you've got enough. If not, close the lower, open the upper and fill until you get a drip from the upper, indicating that it's full. For all of that, if you're planning to work the tractor hard, it's always good to top off to the upper cock, just like you'd top off your car or truck before a trip.
Originally, back when these tractors worked regular and sometimes hard for a living, the Owner's Manual (you need to get one) recommended a regular draining to the level of the lower cock and then refilling to the upper, even between changes. It was expected that there'd be some washdown of fuel, especially with the distillate engines, which would dilute the crankcase oil, and this was their way around that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.