Posted by awhitva on September 15, 2009 at 07:40:34 from (196.201.218.218):
This message is a reply to an archived post by Rob K in Maine on September 16, 2008 at 18:21:56. The original subject was "How to determine year of IH 2bottom plow".
Hey Rob, if you are still out there, I read the number from old post on your plow bottom and my Genius plow has the same number(510378R1)on the back of the points. I am wondering if your moldboards possibly have this number 510374R1? If so, we have the same plow bottoms and they are a little unusual for a Genius plow. This is what I know about them, according to someone who looked up this number: It is 14" HSB (high speed bottom), parts book says "similar to BA series", built 1946 to ?, and its from the Chattanooga Plow Works - an IHC subsidiary.
I can get parts for whole plow, except for these bottoms. I need to replace one of my moldboards, which is cracked. Have you possibly found a parts source for your bottom parts (shares, moldboards, points, etc.)?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.