Tractor Talk Discussion Board |
Re: Super 88 diesel; Cracked Block
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on December 13, 2000 at 14:09:56 from (205.188.197.171):
In Reply to: Super 88 diesel; Cracked Block posted by Nathan Gray on December 13, 2000 at 11:47:01:
I repaired a block with an outside crack once by drilling a small hole about 1/2" past the end of the crack on each end. Then I cleaned the area around the crack with a grinder and cut a groove with the grinding wheel over the crack. Next was the hard part, I lifted the side of the tractor up with a winch truck until the block was almost horizontal and brazed the cracked area. Brazing is not as pone to stress fracturing as other materials used to weld cast iron.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|