Tractor Talk Discussion Board |
JD A oil in pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on December 05, 2000 at 20:20:36 from (206.230.112.93):
I picked up a '47 JD A a couple of years ago, just toying around with it for now, may restore eventually. It runs well, has good compression, tight bearings, and doesn't burn any significant amount of oil (the plugs don't show it anyway), but... I have trouble with oil getting into the pulley. If I run the tractor for a long period, such as on an auger or raking hay, it will actually fling out from between the pulley and the cover, speckling the axle and that side of the tractor. I've had the clutch completely apart several times, and the pulley off the tractor when I first got it to put on a new drive disk and frictions, and replace the toggles and dogs. I can't find any trace of any kind of seal or oil deflector, nor does my I&T book refer to one, just the "threaded" part of the pulley that (I think) is supposed to move oil away from the clutch as the engine runs. An older gentleman who worked on these tractors at a dealership for years couldn't help either. I've tried 15-40, and straight weights of 30, 40, and 50, and I keep the level where it should be, just at the petcock. The evacuator pump in the fan shaft is working, and the plumbing from it to the breather is clear. Any ideas? Thanks! Denny
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|