Posted by Illinois on August 02, 2009 at 12:32:58 from (173.28.98.245):
On the 27th of July, I sent a message to this group describing a drivability problem with my pickup.
It was constantly surging and running rough at between 50 and 70 MPH and the tachometer would move around, maybe a couple of hundred RPM all while the cruise control was off or on, didn"t matter.
I seriously thank all of those who replied, the truck now seems to be fixed, after putting up with this for probably at least three years, maybe four.
More than one person suggested the throttle position sensor, but I want to especially thank BrokenWrench for emailing me several times describing how to deal with this thing.
The sensor was replaced Friday, and yesterday I put 240 miles on the truck, it did not do this once, not once.
Previously, we timed it, we could not go thirty seconds at a time without the rough running.
I had decided that the torque converter had stopped working several years ago, giving it more gas would result in immediate tachometer movement.
Now, I can feel when the converter locks up, and it is apparent on the tachometer.
Giving it more gas now results in the tach reading increasing at the same rate as the speedometer.
Again, thanks to everyone, especially BrokenWrench, if you guys knew how frustrating this was, after going even to the Chrysler dealer and an independent several times with no results, you would know how happy I now am with the truck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.