Posted by bc on July 22, 2009 at 14:32:12 from (71.158.218.38):
In Reply to: Here is a diagram posted by jdemaris on July 22, 2009 at 11:26:33:
Think I'd try would be to unhook the line between the two valve spool banks and bull plug both sides. Then you can isolate each system to try them out. Both spool valve banks still have a pressure relief valve for a return to the resevoir. That may be a good place to put a pressure guage if you have one.
I'd pull all the pop off valves and see if there is any gunk under any of them.
After reading what others are saying, I'm leaning towards the swing valve spool bank or a bad oring or piston seal leak in the swing mechanism. You could isolate that further depending upon if it acts the same when you move the swing as when you move the stabilizers. Do the swing mechanism/cylinder(s) leak and does it make a difference where the swing is such as all the way to one end or the other end or in the middle?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.