First question. When you say tires spin are both tires spinning? From those tires if both are spinning then the tractor has power.
A 40hp machine should be able to pick up 1/2 yard of sand in a pile with the correct technique. A 40hp machine will most likely not fill the bucket if you are trying to ram into mother earth with it.
I am not sure what exactly you are describing as sand in your hillside. If you cannot walk without considerable effort (as the sand is sliding out under your feet), then it is not a bank of sand on your hillside. Likewise if you can grab a handful, squeeze it and any (and I mean any) of it compresses into a ball it is not sand.
I am starting to think it is a combination of something other then sand and a lack of technique. Are you curling the bucket at all or just stabbing it into mother earth straight forward and expecting a full bucket? Have you tried back bladeing the hill to loosen it up then try to bucket it up?
As far as being had, the only one fooling anyone is you. You went and purchased a 50 year old machine without even testing it out before purchase? Granted it sound like you have no clue in regards to the operation of the machine and that is fine, but you could of at least asked the previous owner to demonstrate.
You have there about $600 in scrape iron. $1900 for a machine that runs and drives and quite possibly works with a 1/2 yard bucket is a bargain in my eyes given your application.
Here is an easy test. Put the bucket all the way down and see if it will lift the machine at all. If it does then go find someone to show you how to use it properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.