Tractor Talk Discussion Board |
more questions re smokin'oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carla Ricci on October 11, 2000 at 19:02:53 from (205.188.197.46):
To all of you who have responded to my questions so far, thanks ! Here are some more: 1) what's the ideal oil for a Ford 8N ? and how much ? 2) should there be oil in the inner ring of "pan" below the air filter as well as the outer ring ? 3) compressions test for 8N: what do I need to know ? 4) "E118" on engine block means what ???? 5) can I use tractor for another ten hours to finish remaining fields and then deal with serious problems , or will I cause irreparable harm and need to tend to them now ? 6) This tractor is noisy: what kind of new muffler would cut down on noise and would the change be worth the price ? 7) some bolts were less than tight and two were missing under engine block and oil filter...do I need to get Ford bolts or can I improvize. Loose ones have been tightened. Amazing the things you discover when you crawl around under a tractor ! Best, CR
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|