Yes, to re-emphasize exactly that, firewatch and fire safety, we always had someone assigned to that task when I supervised ironworker crews, and still theres that tarp in a shaft or inaccessible place where there's welding going on above, slag and molten metal dropping down from upper floors, tarp now burning, seen it a dozen times on sites.
The value of fire watch goes a lot further when working in a building, a fitter was soldering some copper pipe in the main office of the lumber yard where I worked, established 1888, made 100 years, but that year 101st, she burnt mostly to the ground and there was absolutely no stopping it, one of the 2 worst fires I have ever seen first hand, the other was my friends farm that was intentionally set in his shop on fathers day '95. The lumber yard fire was directly caused by the fitter, late friday afternoon, bitter cold too, I punched out, he was working in the ceiling between the joists, scorched the wood and or left embers or something smoldering. You soak the area first, and start that job early in the morning, for just the same reason, so you are there to catch it if it does go up. We heard it on a scanner, I went down and watched it burn, the old carriage house turned into a pine lumber shed/stocking area, cool old building, gone, most of the main office and upper floors of the hardware store, it melted a roll of coins in the owners office, some say it was done intentionally. Funny thing was my charred time card was still pretty much intact, the next day, I was the only one who came in, everyone thought they were off, saturday, place burned down, nope, they set up phones in the mill next door, and I took all the delivery tickets, filled the orders we could and made all the deliveries. Stupidity, he should have done things a little differently that fitter, dummy burned the place down, risked a lot of firemen, and days later during the demo, 2 natural gas laterals, 2" lines were spewing gas, 2 days before anyone reported it, another disaster averted, fire & safety aint nothing to fool with..... ever.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.