Tractor Talk Discussion Board |
Re: Re: Re: Need Wiring Advice
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on September 02, 2000 at 09:10:12 from (63.160.195.97):
In Reply to: Re: Re: Need Wiring Advice posted by Bob on September 01, 2000 at 19:04:30:
The alt light should have one wire from the switch and the other from the #1 terminal on the alt.When the alt is not charging the alt light is grounded through the #1 terminal which makes it light when the ign is on,when the alt begins to charge the # 1 terminal goes from ground to + 12V so both alt light wires have 12V which makes the light go out. The problem may be with the one wire regulator. Try hooking the #2 wire in the alt plug to the bat connection on the alt rear. This would also let you use a std (not one wire) regulator although the one wire reg should work. The one wire reg manufacturer says you can do it this way and it will make the alternator kick in at lower rpm. Make sure the wire from the bat terminal on the alt rear goes directly to the bat( where the battery cable attaches)terminal on the starter.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|