If you're only going that deep, drive it by hand. Well head is 3 or 4 feet, compression coupling, 5 foot section of pipe, compression coupling, and hydrant or keep adding as many compression couplings and sections of pipe as you need. And don't confuse a regular coupler with a compression coupler cause they aint the same thing. And don't forget the pipe dope. But because of the hydrant are going to want to bore to below the frost line. I've gone 25 feet by hand with 2" pipe but that's a workout. Can probably rent a hand driver from your local hardware. Is like a 3 foot piece of solid axle with a 100 pound weight on it. Get an extra compression coupling to drive it cause its going to take a beating. The shaft goes down into the pipe as a guide, and lift and drop the dead weight, or if you're ambitious and have to go 25 feet or so, lift and slam down on it as hard as you can...but watch them fingers. The deeper I got, the less it drove...like about an inch or half inch per slam. It works though. Quite a workout. Good for the biceps. Gets the blood pressure right up there and makes you kind of sweaty. I've done it a few times. Smokin and gettin old don't help much.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.