Posted by John T on February 07, 2009 at 20:19:38 from (98.115.40.108):
In Reply to: Re: High output coil posted by relaurain on February 07, 2009 at 16:29:08:
Youre right, it might?? foul less BUT ONLY FOR A WHILE UNTIL THE POINTS BURNED UP (thats if you increase the current draw). Points can switch around 4 amps (and still have a decent lifespan) or so but if you increase the coil current by using a high energy coil that draws more amps, they will burn up quicker. Thats why its best to use an electronic switch which can handle more amps then points were designed for and when its matched with a high energy high voltage coil and a wider plug gap is used THEN YOU GET THE REAL ADVANTAGE and get all the bang for the buck an elec switch and high energy coil have to offer....... Sure one can widen the plug gap with a stock coil and perhaps gain some improvement, but the laws of physics and conservation of energy apply and theres only a fixed finite amount of energy stored in the coil during its conduction cycle and thats alllllllll (less heat losses) the energy available for discharge across the plug gap. Therefore, if you widen the plug gap increrasing the firing voltage, then either current or the arc duration time decreases since the energy discharged is volts x amps x time..
Dont get me wrong THERES NO HARM in running a high voltage coil if it doesnt draw much more current then the points were designed to switch although it still fires at the same voltage as the stock coil if compression and gap remains the same. Its just that if you use coils that draw more amps the points will burn up prematurely
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.