Lanse, how can you tell the water pump is leaking at the shaft seal? From what I can see, there's plenty leaking from the thermostat housing down onto that whole area. Kind of hard to tell from what I saw in your video. There's not a lot to that pump, its a pretty small guy with an impeller at the block, a snout, a seal at the impeller shaft to the pulley, and three bolts to mount it. I don't remember a weap hole. Might be one, but I don't remember there being one like fuels pumps have. I've got one lying in the barn that I replaced because of the seal, but I'm not home to take a look at it until next weekend. If it is in fact leaking behind that pulley, its going to be that seal or a crack. But it sure is hard to tell with all of that leaking down right on top of that whole area from what I can see. That's an awful lot of leaking. I'd fix that first before going after the water pump, cause from what I can see, it just may not be leaking. I made (cut) my own gaskets ot of gasket material and used Permatex No. 2 on both sides. And them caps on them mags sure don't like moisture. Seem kind of porous to me and regardless of setting in a dry barn all winter, I still find myself pulling that cap off and cleaning it and the terminals first fire up every year. And good shift boot or not, them shift levers work like a lightning rod for water, so become a water rod so to speak that guide that rain water right down into the trans, and that'll add up to contaminated gear oil down there in time. Been there, done that. Good luck, and I'd take 50 degrees.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
