The ball mic is an adjustable device that is placed in a hole and expanded to ft. It is then measured out of the hole to assess the size. When using the same instrument to actually measure the inside and outside Diameter, one gets a good measurement. With rust in the cylinders, it will be necessary to disassemble the engine. If it is light surface rust, and the engine is basically able to be turned over, it deserves looking at the wear on the sleeves to see if they are usable. If you can feel a step in the bore of the sleeves where the top piston ring stops on its travel upward, it needs to be measured. THis spot is the heaviest wear location in the cylinder. If the step measures more than .005" in diameter difference (measured at the very bottom of the cylinder, compared to the widest at the ring wear) it will be necessary (and cheaper) to buy a kit for the engine (about 650 or so fro m this site, or other sources. Shop. RIngs, pistons, and a bore/hone on the existing cylinders will be more than the kit. Best of the season, and of luck. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.