Posted by P and R Pete on October 13, 2008 at 15:26:32 from (66.33.250.76):
I have a 4-wheel drive Kia Sportage. The front hubs are engaged via engine-vacuum: a vacuum line from the manifold goes to and exits a small tank, and then to an adjoining solenoid that opens the vacuum to the hubs, After that, a simple T-joint directs the vacuum to each hub.
I have 20 pounds of vacuum on the wheel-side of the solenoid when shifted to 4-wheel drive. Seems OK. Vacuum at the R wheel is 20 pounds, at the L wheel about 13, so I guess I have plaque in the L artery. Regardless, it isn"t shifting the hubs. I haven"t yet taken a wheel off to get a better look at the hub, but question is, is there any maintenance/lubrication that can be done to the hubs to free them up?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.