Hi Mike! I did just as you suggest. I used some white out to mark the meshing gears, but when wiping off the excess paint the cam gear jumped about three teeth on the governor gear. Now I’ am thinking the two gears had already jumped, that is why it no longer wanted to start.
According to the Lincoln manual I downloaded from Lincoln’s site, and the CD manual I bought, all timing is based off of the number four sparkplug. At one time this welder started very easy. Then All of the sudden a pin in the magneto coupling broke. I replaced the mag coupling with another mag I had. Now I believe the reason this pin broke is because the bushing / bearing in the cam gear let go. I was just reading in a page I downloaded from Bill’s Welding Equipment Repair site that there is suppose to be a single punch mark on the cam gear tooth which aligns / meshes with two gears on the governor gear that are also punched. For the life of me I cannot see these punch marks, even with a magnifying glass! I guess I’ll take everything apart tomorrow. Took all morning to find my wheel puller. Man I hate when I can’t find a tool! :o(
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
