Posted by bradley martin on September 11, 2008 at 12:33:34 from (216.209.148.135):
In Reply to: 430 case pto shaft posted by Russt71 on September 11, 2008 at 08:52:31:
I assume that you are talking the PTO stub shaft that you would attach a machine to and not the PTO drive shaft that trnsmits power from the engine to the rear of the tractor and in turn drives the stub shaft. If so, there will be no reason to split the tractor. The entire PTO housing can be removed from the rear of the tractor,and the long drive shaft that runs from the PTO, thru the transmission to the bell housing will come out with the housing. This will allow you to replace the stub shaft. Be very careful when re-inserting the drive shaft as there is a seal that can be easily damaged. You may want to remove the top cover of the rear end so as to guide the long shaft properly. Go to the Case IH web site for parts for an exploded view of the PTO set up. Also, spending $ 20 on a shop manual would be a good investment. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.