Posted by NCWayne on August 28, 2008 at 15:07:22 from (166.82.187.40):
In Reply to: Clean Air Act posted by DOZER GUY on August 27, 2008 at 22:54:06:
Like others have said it must be a local thing. I don"t know about scrapping whole machines and putting holes in the blocks accomplishes much of anything because you can still get an engine for the machine, hole in block or not. I just read an article concerning reman engines and the only Federal mandate concerning the selling/installing a reman engine is that the reman has to be at least at the same tier or higher than the engine it replaces. Basically to do a reman the mfg has to reclaim the old engine and either "capture" or destroy it. In other words they have to get a core of the same type engine you get and either rebuild that engine or scrap it. There can be less of that particular engine in the system, accomplished by destroying them, but there can be no new ones build they can only rebuild/reman the ones already in existance. If it were me I"d see if I could get the machine for scrap price and go from there. Depending on where the hole is often a block can be repaired without alot of problems. There"s a shop local to me that"s been doing repairs like that for years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.