Posted by kyhayman on June 26, 2008 at 09:02:46 from (75.105.7.211):
In Reply to: gooseneck hitch posted by PJBROWN VT on June 26, 2008 at 07:30:55:
Local welding shop did mine. He pulls the bed, uses a pc of 10 inch C channel with the C down and a pc of 8 inch C channel with the C facing up, connects with a pc of pipe the diameter of the ball and welds to the frame rails. Ball is a 30,000 pound g.n. ball. To remove the ball, there is a pin in the bottom of the shank of the ball to take out and the ball lifts out. So farm I've been happy, its pulled close to its rated capacity, and tows at least 2-3 times a week since installed in 2000. They charged 175.00 labor and materials. Truck (Dodge 2500, was prewired for brakes so all I had to do was add a box).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.